Reyrolle IED direct connection to SICAM SCC

Reyrolle IED direct connection to SICAM SCC
Reyrolle IED direct connection to SICAM SCC

This is a project in 2018 in which I have been involved, retrofitting the old Protection Device into Reyrolle IED. See the picture below: It is about 140 IEDs that are connected to SICAM SCC. This is one of the Sample SICAM SCC Applications without SICAM PAS on the Substation Automation System.

This scheme of SICAM SCC application will only give the local monitoring, when you need a connection to SCADA Systems, you might consider using SICAM A8000.

Reyrolle IED direct connection to SICAM SCC

Reyrolle IED direct connection to SICAM SCC
Reyrolle IED direct connection to SICAM SCC

What is the benefit of using this application model:

  • Saving Budget Cost Project
  • Simple & Easy to Configure and update
  • Redundant system

Disadvantages of using this application system:

  • Need additional devices like SICAM A8000 if the system required a connection to Control Center
  • Limited Communication Protocol Interface

Finally, this sample application configuration will be better for the local monitoring system without sending the data to another system monitoring.

Read Also:

IEC 101 vs. IEC 104: Understanding the Differences


Discover more from Sugeng Riyanto

Subscribe to get the latest posts to your email.

By Sugeng Riyanto

Substation Automation System Engineer

Discover more from Sugeng Riyanto

Subscribe now to keep reading and get access to the full archive.

Continue reading