A common type of fiber optic connector

A common type of fiber optic connector, Fiber Optic Connector is an important aspect of a system design or application. I have some experience using 3 common types of Fiber optic connectors at work. Within a short length of communication, you will need a Multimode fiber optic or a Single Mode fiber optic for the wide range length.

A common type of fiber optic connector
A common type of fiber optic connector

The connectors of fiber optic will help to connect a device to a switch or communication device. Please note that the cost of using fiber optic is too high when you only need regular cable on your network. It is worth it while you know what to do in the application. Stable communication will help to improve the system’s performance.

A common type of fiber optic connector

Moreover, when you need to join the optical fiber network, to connect or disconnect you will need a special connector. Due to the polishing and tuning procedures that may be incorporated into optical connector manufacturing, connectors are often assembled onto optical fiber in a supplier’s manufacturing facility.

Notes: Most optical fiber connectors are spring-loaded, so the fiber faces are pressed together when the connectors are mated. The result of glass-to-glass or plastic-to-plastic contact eliminates signal loss that would be caused by an air gap between the joined fibers.

Common Connector of Fiber Optic
Common Connector of Fiber Optic

The most common connector of fiber optic for industrial application is, LC, MTRJ, CS, ST. Have you ever used one of these connectors? The stability of communication is a high-priority aspect to consider. A large system for Protection of Power distribution will have tons of data to transfer for a specific minimum spec.

Read Also: Alstom Gateway to SICAM A8000 RTU Upgrading

Finally, you can use fiber optic in industrial applications that need a large amount of data transfer in seconds. Within a single process of manufacturing products will have some communication from a device to the system. However, the stability of the connection is the most important aspect to consider when it needs to use fiber optic. If you like the topic, you can continue to the FOA Reference Guide.

Leave a Reply